LEGᴑ Star Trek Enterprise 10356 Wall Mount

Credit for this original model goes to https://www.thingiverse.com/Illogicalcpt

I have created a ‘slim’ version of this model that relies on a wall stud. I do recommend using a stud or metal wall anchors if you value the safety of your Enterprise. This model has been modified to print successfully on Bambu lab printers.

PETG or stronger is highly recommended. DO NOT USE PLA. Use pointed screws to secure model to the wall and to the print itself, my recommended screws are pictured.

Instructions:

1. After printing all needed parts, insert the ship holder onto wall mount, align the cross and insert with pressure, it will be tight.

2. Install a medium screw to secure the two pieces together:

3. Combine the 3 pieces together, a lot of pressure will be needed, be careful, a rubber mallet might be needed to get all the pieces together

4. Locate a stud in your wall using a stud finder

5. Drill the first screw, use a long screw to secure it into the wall through the stud

6. Level the wall mount before installing the top screw

7. To secure the minifigure and plaque holder to the wall mount, use small screws

8. Push the mount with the studs facing outwards upwards and back towards the wall, drill the screws on both sides of the holder:

9. A lot of pressure will be needed to put the Legᴑ parts onto the non-legᴑ studs, you may need to disassemble the Legᴑ stand to put it on the fake studs, the locations for the pieces are pretty straight forward as pictured.

10. Place the ship onto the holder in the two vertical inserts