Case for Monimoto 9 Key Fob

This model is a replacement case for the Monimoto 9 key fob. It was designed to hold the internal components from the original casing and restore normal use after I broke mine. The internal dimensions match the original enclosure closely, allowing an easy fit once the circuit and battery are transferred. The case itself is significantly smaller than the original and also slightly thinner.

The case can be printed with standard materials like PLA, PETG. PETG is recommended for better strength and resistance to wear.
 

Notes:

• Printing face‑up without supports, the locking wholes may get a bit smushed but they'll work fine

Disclaimer:
I am not affiliated with or endorsed by Monimoto. Monimoto is a registered trademark of its respective owner. This model is an independent design shared for personal use and repair purposes only.