Tx22 16 and 18rd magazines

yep just change the filament to the filament of choice and then go to supports and uncheck the support material box

My bad. I guess what I meant to ask was can it be printed in another material that will hold up that isn't CF? I'm not sure I have adequate ventilation with my P2S setup indoors.

i would use PET-CF and the ventilation should be fine in a p2s. the carbon fiber gets filtered out by the hepa filter. PET im pretty sure is just as harmless as PLA and PETG so you should be good to go. its better than PPA-cf in some areas

very bold of you to assume this files from the sea. considering how many of these mag stls are out there on various sites. i get you have you own magazine on the sea but this is not it i can assure you that much.

I made the 18 round body to fit the spacer I made for the 16 round mags in the compact. I also made the 13 and 14 round compact mags at the same time. Don't worry they're not on the sea now thanks to you but I'm the ONLY one who had a compact mag. This is my design. It's the only 18 round body floating around and you put both of them in one 3mf and sent it. You still have my 6mm tall base pad as well which fits loose that I planned to fix. Glad I didn't now.

good to hear brother!

Any suggestions on loading the spring? I bought the green springs from tandemcross. When I try to apply pressure to the spring as if I'm going to load shells into magazine, the spring bends and slips into the main body area of the magazine. Before I print a dozen of these, I need to make sure they are usable...

I found a 10mm .6 spring on Amazon that works great, just need to cut it to the right length

thanks bro

You're welcome

all of mine are done in ppa cf if you have abrasion issues change the layer height

sorry you used the wrong filement. ppa cf works great so does pet cf