F 16-c

F 16-c

Boost
568
1003
108

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini
H2D

0.2mm layer, 2 walls, 10% infill
0.2mm layer, 2 walls, 10% infill
Designer
4.8 h
1 plate
4.4(75)

0.2mm layer, 2 walls, 10% infill
0.2mm layer, 2 walls, 10% infill
5.9 h
1 plate
3.8(6)

Open in Bambu Studio
Boost
568
1003
108
66
2.1 k
738
Released

Description

Reproduction of F 16-c. This is a multi-role aircraft with a maximum reachable altitude of around 15,000 metres. It has been chosen by the air forces of 25 nations[4]. The F-16 is the largest Western fighter aircraft project, with over 4,500 examples built since production began in 1976[4]. Although it is no longer purchased by the US Air Force, newer versions of it are still produced for the foreign market. In 1993, General Dynamics sold its entire aircraft manufacturing business to Lockheed Corporation[5] which then became Lockheed Martin after its merger with Martin Marietta in 1995.

 

Note: use only this settings. This model needs post production and glue.

Comment & Rating (108)

(0/5000)

Print Profile
0.2mm layer, 2 walls, 10% infill
Printed in glow in the dark filament. Turned out amazing!
(Edited)
6
Reply
"How did you make the wings of the plane? I couldn't print them. They either come off the tray or print incorrectly due to the support."
0
Reply
very nice model. my son loves it.
(Edited)
The designer has replied
1
Reply
thanks ☺️
1
Reply
"How did you make the wings of the plane? I couldn't print them. They either come off the tray or print incorrectly due to the support."
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
bad on support very had to remove and it’s breaking the print on wings
0
Reply
"How did you make the wings of the plane? I couldn't print them. They either come off the tray or print incorrectly due to the support."
0
Reply
everything worked but the overhang was a bit much so lots of spaghetti
0
Reply
PETG Thanks! Nice model!
Show original
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 10% infill
Great Model! I had some issues with gluing together (glue wasn't great) but other than that no issues.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
came out quite good, my son loves to play with it (printed without landing gear)
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
not perfect but very fun
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Excellent
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
This model printed well! Hoever I did notice some of the parts did sag. Also, the pitot tube did break off while assembling. Nonetheless, a great model to have on my desk!
0
Reply

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.