Search models, users, collections, and posts
Dual slot cable tie anchor
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
16 min
1 plate
Open in Bambu Studio
Boost
14
26
0
0
29
7
Released
Description
Simple dual cable tie slot drill in anchor for cable management.
2x M3.5 self-tapping screws per anchor
Print in any filament you like. DO NOT turn on supports. The model can bridge just fine. If you turn on supports, you will have a hard time cleaning out the hole.
Loop the cable tie through the hole to fasten down your cables for some nicer cable management.
I figured that I'm not going to be changing my cable configuration that often, as such I don't really need to have “reusuable” clips that are bigger and less sturdy. Just drill the anchor in and lock up your cables using a zip tie.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)