Circuit Maker 3 & 4 Stand - Max Height 250mm

I made few changes on this remix according to my needs:

Already had -

1. Cricut Maker 3's original rubber feet can fit on this stand. No need to print extra TPU feet.
2. use the original screws to attach the 4 plugs on the machine.

Changes:

1. Height is maxed to 250mm - as i wanted my HP Smart Tank 7605 can be placed under the cricut.
2. To make the print stronger, I layed it flat and cut that extra bit from the feet, so no support is needed to print it.

*   Because of the height, it shakes a little while cutting, but i had no issues so far, although I haven't tried cutting smaller prints yet.

** If you need a specific height (less than 250mm) let me know and I ll do that for you :)