Ignition cover for derbi/rabasa euro 2

simple and eye catching custom ignition cover for bikes with ebe050 and ebs050 engines, mainly derbi bikes. 

i have provided two different middle disks, one blank and the other with holes and a spot for a design in the middle.

intended to be used with Allen bolts. there might be difficulties fitting hex head bolts.

Print settings:

20 - 30 % infill, i used 20% cubic

Petg or Abs/Asa. i don't recommend Pla if the exhaust is close to the cover, Pla may work with low mount exhausts but not recommended since the engine can get quite warm.

Enable supports

2 colors can be achieved on a single color printer by adding color changes in slicer. 

Disclaimer

The real life pictures show an earlier prototype that is not quite as pretty as the one in these files listed in this Makerworld post. As off right now i don't have photos of the best version. The tinkercad photos are up to date and completely representative of these files. Only difference is the curvature on the top