Tesla P100 Case
Print Profile(1)
Description
I used official PLA filament for printing. Only the case requires minimal support, taking about 3 hours. The fan used is 80mm, with a 72mm hole spacing and 10mm thickness. The fan mounting location has been reserved during modeling, so no copper standoffs are needed. You can use M3-6 or M3-8 screws, depending on the fan you choose. For mounting the case, you can use the screws from the original graphics card.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)