I was asked if it perhaps was better for the drying effect to make the walls different so air could get trough.

So here it is , my voronoi silica drying basket with screens of rectilineair infill.

I have used standard bambu profiles with petg which printed perfect and after testing i made it from ABS .

Be sure to pre-heat your printer to a minimum of at least 45 degrees and be sure to check your print when it prints because mine still warped a little bit causing to rise the plate loose from its base.

I am pleased with the result but as my experience is not that great with ABS the settings could surely be better tweeked, please let me know helpful tips for printing ABS without/less warping.