Search models, users, collections, and posts
Coax Mounting Points for Rohn Tower Legs
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
3x 0.2mm layer, 2 walls, 15% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
13
34
0
0
18
10
Released
Description
These mounting points are intended to be zip tied to the legs of a Rohn 25/35/45 tower. The leg diameter is the same for all three tower models. There is additional space in the center channel to install another zip tie to secure coax/control cables or the cables can be secured to the side posts.
I recommend printing in ASA/ABS if possible for long term use. PLA will hold up for light or temporary use.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)