Simple thermostat housing for e.g. Bambu Sauna

After trying several variations of the Bambu Sauna I ended up picking parts from multiple models. I didn't like the idea to route 220V AC into my printer as many of the designs do so I decided to create a 24 Volt system I found that the thermostat housings didn't suit my needs. So I designed a simple one that attaches to the top of the printer. It is not as powerful as the high voltage versions but a lot safer in my opinion.

Yes, I know it is not elegant but it works. 

Both side versions included into the model files. No supports needed if you keep the orientation that is in the model file. ABS recommended as material.

Then thermostat I used was the DC 24 Volt version of:

https://www.aliexpress.com/item/1005007558716513.html?spm=a2g0o.order_list.order_list_main.5.11b81802Ayc59h

I routed the temp probe to top right corner of my P1S.

Other parts I used:

350W 24V power supply:

https://www.aliexpress.com/item/1005007861410275.html?spm=a2g0o.order_list.order_list_main.30.11b81802Ayc59h

Wall mount cover:

https://makerworld.com/en/models/1066096-wall-mount-cabinet-for-mw-lrs-350-24-power-supply#profileId-1055164

24V 200W heater:

https://www.aliexpress.com/item/1005007442989854.html?spm=a2g0o.order_list.order_list_main.20.11b81802Ayc59h

Housing for heater:

https://makerworld.com/en/models/669084-bambusauna-two-piece-bambulab-x1c-p1p-p1s-heater#profileId-596725

I modified the heater box with dremel to add a 40mm 24V fan on the side to increase airflow (again not pretty but functional):

https://www.aliexpress.com/item/32769608982.html?spm=a2g0o.order_list.order_list_main.25.11b81802Ayc59h

I control the heaters with wifi AC sockets to make sure the heaters are not kept on unnecessarily.

I hope you find this useful.