Baby Wipes Box with Sealing Lid

Holder for standard Baby Wipes / Wet Wipes including easy dispenser that perfectly presents the next wipe. Jazz up your bathroom or change room with a nice box in your choice of colours. Fits standard 80-wipe soft packs: rip off the plastic cover on the soft pack, pull a wipe out a little bit and poke it through the special ‘Moustache’ hole dispenser!

107mm x 177mm x 72mm

4.2in × 7in × 2.8in

(fits standard 80-wipe soft packs)

Printing Information

Only two pieces: the box and the base. The box has a hinging lid with solid latch: pull out a wipe and the edge of the next one is pulled out a little bit ready for next time. Close the lid and you seal in the moisture. The base presses in place and stays put for the famous “hold baby in one hand, pull wipe with the other” pro move!

After printing, the lid should “peal” away and then hinge back: there will be supports inside for the cavity between the lid and the ‘wipe seperator moustache’ an innovative but effective shape to ensure pulling a wipe out leaves a fresh one ready to go. Fold the wipe to the side and close the lid: the lid snaps shut.

The video below shows the simply steps to perform after you finish printing

Happy wiping! 

 New and Improved V3 29 Jan 2026!

• Increase in height of the box: realised with a new pack of wipes that the gap at the top is too tight and that the base is hard to close
• Increased the height of the base and the ridges that keep it fixed in place: it now withstands one handed operation and you can lift the box when pulling out a wipe and the base won't fall out

V3 includes the V2 improvements:

• The clasp is now bigger, stronger, and easier: a single overlapping lock while still being print-in-place
• The width of the cavity was increased as well as made deeper to better accomodate the next wipe when closing the lid