Milwaukee Fuel M12 Vac Chamber Converter

Converts Milwaukee M12 1.6g vacuum bottom into a rectangle so that you can custom make a vacuum chamber.
 

I had a need to make a custom larger bottom chamber so I made this converter. The rest of the bottom was made out of wood and sealed with some caulk I had laying around. I did not see a reduction in the suction of the vacuum.

It uses 4 M3 bolts to hold the two sides together and then I used the original hardware for the latching mechanism.

Note: In the pictures I had to print an extra spacer but I updated the model that is attached here so that it is not needed.