some came out perfect while others kept breaking or falling over. I went back in and added supports to all of them after a few failled attempts and also increased the wall loops and they came out good. the bow tie ones, a corner kept chipping off and I couldn't figure out how to stop that. but they will be very cute earings

kenley

0.2mm layer, 2 walls, 15% infill

I never could get the farfalle to print properly.  The first attempts were spaghetti monsters.  After I got that taken care of the ends kept breaking off.  The ravioli took some work for the same reason. Oddly the one that worked best for me was the cavatappi.  Perfect print every time, I printed a set scaled up for my daughters ceiling fan.  

user_1121322040

Manamah

derkla87

Adorable! I can't wait to wear these in Little Italy/ North End of Boston at dinner!

Robin

Lucy

theprintlabYT

that look tasty! I’ll tell yall if they are

The support settings need a lot of adjusting. As set, they are too strong and I broke 4 of the earrings on my plate of 16. The ones that came out OK came out nice.

JPMACK 3D Prints

With supports - 0.2mm layer, 2 walls, 15% infill

Javisetic

Suri3D

The cavatappi kept breaking as I was removing supports, but the rest of them are fantastic!

pellypalace

cover

Screenshot 2025-12-30 at 5.04.58 PM.png

Screenshot 2025-12-30 at 5.05.07 PM.png

Screenshot 2025-12-30 at 5.05.11 PM.png

Screenshot 2025-12-30 at 5.05.16 PM.png

Screenshot 2025-12-30 at 5.05.21 PM.png

Cavatappi

plate_1.png

Ravioli

plate_2.png

Penne

plate_3.png

Farfalle

plate_4.png

2025-12-30_df8bd510ade5d.png

user_3935107019

image.jpg

With supports enabled to reduce print failiures.0.2mm layer, 2 walls, 15% infill

<boostme><boosttitle>Boost Me</boosttitle><boostcontent>As I&#39;ve opened this model for commercial use, if you enjoyed it, please give me a boost or a 5 star rating. Thank you!</boostcontent></boostme>Four different pasta charms that can be turned into earrings, necklaces, keychains, etc! Each one has a built in negative space of 2.5mm for attaching a jump ring. Each plate prints just one set of earrings. Please be careful when removing the supports! <ul><li>Farfalle = minor supports</li><li>Ravioli = minor supports</li><li>Penne = minor supports</li><li>Cavatappi = the most supports (for the spiral shape)</li></ul>

Pasta Charms

ASIA

Print Profile(2)

Description

Comment & Rating (32)

License

Related Models