Search models, users, collections, and posts
CDX.V9.3 3 inch fpv drone whoop mounting
IP Report
Print Profile(1)
0.8mm nozzle, 0.56mm layer, 2 walls, 100% infill
Designer
1.2 h
2 plates
Open in Bambu Studio
Boost
2
4
0
0
2
2
Released
Description
It’s still not perfect, but I probably won’t make any changes because I’m working on other frame designs.
M3 and M2 plus are needed.
Please use washers.
For the best print:
0.8 nozzle, largest layer height possible,
less cooling, minimal over-extrusion,
high temps (+10 C higher than normal),
infill 100% and concentric,
and most importantly: print by object so every layer is still hot for maximum layer bonding!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)