Search models, users, collections, and posts
Creality Ender 3 or 5 Auto Level Mount for M12 probe
Remixed by
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
3
7
0
0
9
3
Released
Description
Summary
This is for a m12 probe, I used it on the Ender 5 and you might have to bend the crimped belt fitting thing to the side to get the probe in or just cut a tiny bit off with your cutters.This will mount left of the hot-end,I had to mirror this to fit the ender 5 with out bumping.I will post the off sets latter
Config uploaded is for a Ender 5 (Stock Board), ABL, NO SD (i use octoprint) 2.0.5 Marlin.
Probe- LJ12A3-4-Z/BX
Blue- Ground - (Used Motherboard input power connector)
Brown- 12/24 + (Used Motherboard input power connector)
Black- Signal pin on z end stop
Print Settings
Printer:
Hypercube Evo
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20
Comment & Rating (0)