Raspberry Pi4 Innomaker DAC Case

This is a remix of the following model

https://www.printables.com/model/649158-modular-case-for-raspberry-pi4-and-an-hifi-hat-aud

I use Raspberry Pi 4 models for my Volumio installation and use the Innomaker DAC as a sound card. Since I only found cases for Pi 4 models with Hifiberry DAC Hats, I modified the linked model to accommodate an Innomaker DAC. The original case was raised by 4mm, and the bezel for the RCA and jack outputs was adjusted. Now the DAC Hat fits very well into the case

I printed this in PETG-CF (regular PETG also works, of course), as the Raspberry Pi's temperature gets too high for PLA, causing the case to warp

The bezel only fits the InnoMaker HiFi-DAC Hat with RCA outputs! Not for the PRO version!

Support with separation filament (PLA as a separation layer!)

For assembly, screw the standoffs directly through the Raspberry Pi's holes into the case. Then place the DAC, mount the front bezel (it works best when inserting both together), and screw the DAC Hat from above with the standoffs. Finally, put on the lid and it's done