Search models, users, collections, and posts
Sanci Filament Spool Storage Holder
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
9 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
38 min
1 plate
Open in Bambu Studio
Boost
0
0
0
0
0
0
Released
Description
Content has been automatically translated.
Because I personally found Sanci filament to be cheap and easy to use, I bought a lot of it, but each time the leftover colors were difficult to store, so I made this storage accessory. It can be easily installed into the 8 holes of the filament spool to secure leftover filament, and it's also easy to remove. It requires a bit of finger strength during installation; I just pressed it in firmly. The item is very light and will not interfere with the filament's rotation.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)