Search models, users, collections, and posts
Pulley set
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
29
73
0
1
249
15
Released
Description
- Guide pulley for slow speed flat belts.
There are two versions one with a 608 bearing bore and the other version is with a 6201 bearing.
Version 608 dimensions : 36x60mm
Version 6201 dimensions : 42x60mm
----------------------------------------------------------------------------------------------------------------
- Pulley for belt type SPZ/Z with diameter 67mm.
There are holes for 6201 bearings on the pulley, unfortunately it cannot be fitted with taper bush. The pulley can of course also be used as a pulley for the rope. I recommend to increase the wall thickness significantly due to abrasion. - I recommend in both cases to increase the wall width in the slicer , add 80% infill and then sand with fine paper after printing.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)