Printplate Buildplate holder A1 Mini 10 plates

This is my version of a 10 plates Plate Holder, inspired by the designer: PrintLab3D and his version for the large H2 series plates. I also created a version for the small plates of the P1 X1 A1 series with 256mm.

With this holder, inserting the plates is very easy because the openings have a chamfer and clearly visible slots from the front. The spacing of the plates is wide enough to grip them well.

NOTE: The BambuStudio file contains the print-ready parts. If you have a larger print bed, like those of the H2 series, you can also print the frames in one piece to save screws and gain more stability.

Required Parts:

8pcs. M3x16 countersunk head Connection frame with slider

4pcs. M3x14 countersunk head Connection frame parts top and bottom (not required if the frames are printed in one piece)

4pcs. M3 nut Connection frame parts top and bottom (not required if the frames are printed in one piece)

4pcs. M3x16 Panhead Connection feet with bottom slider

Assembly:

1. Screw the feet with the M3x16 Panhead to the slider which has 4 holes on the bottom side.
2. Screw the two frame parts together with the M3x14 and the nuts. (not required if you printed the frames in one piece)
3. Screw the frames to the sliders. Make sure that the sliders have rounded edges on one side (facing you on the print bed); these should face forward to facilitate inserting the plates. The surfaces that lie on the print bed then point forwards or backwards.