Print Profile(2)
Description
Mini Utility Torch Led Light
Notes:
-You will have to source your own Power supply, LED. I just cut up an old short strand of battery powered Christmas lights.
-Please don't change the profiles I set up in the project unless absolutely necessary.
-The “flame” piece MUST be printed in Vase mode and will NOT fit or reflect light properly otherwise. Make sure to double check!
Instructions:
1. Print out all the parts.
2. Feed the wire down through the top of the handle. Make sure to give yourself plenty of wire to go all the way through the bottle and out the bottom so you can reattach the battery pack.
3. Pull wires through bottle and attach handle.
4. Reattach the switch pack and mount in an accessible location on the inside of bottle using 3M tape, Velcro, glue, etc.
5.Install tip, Knob, Flame
Fire it up and Enjoy!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)