CC3D Spool-Mounted Filament Clip (AMS-Safe)

All Compatible Lightbox Frames & Mounts Available Here!
 

🛠️ Recommended Gear

Check out my Amazon Storefront by clicking here!

Bed Adhesion (Fix First Layer Issues)         Magnets (for optional mounts)

Recommended LED Light Strips     Battery Powered LED Light Strips     Double Sided Tape for Lens: Optional

Custom One-Off Designs Available - CLICK HERE

Printing tips are located at the bottom of this listing

___________________________________________________________________________

These spool-mounted filament clips are designed specifically for CC3D filament spools and attach directly to the inside rim of the spool, keeping loose filament ends secure without interfering with printing or AMS operation.

This low-profile design stays with the spool at all times and uses minimal filament, making it a clean, efficient solution for filament management.

✅ Key Features

• Mounts to the inside rim of the spool
• Low-profile and snag-free design
• AMS-compatible (no external protrusions)
• Uses very little filament per clip
• Quick and easy to print
• Secure hold without kinking or damaging filament

⚠️ Important Compatibility Note

👉 These clips ONLY fit the CC3D spool style shown in the photos.
Please confirm your spool matches the same inner rim and spoke layout before printing.

📸 Photos Included

• Individual filament clips
• Clip installed on the inside rim of the spool
• The exact CC3D spool type this model is designed for

🧵 Printing Notes

• Recommended materials: PETG (Print Profile Posted), or ABS
• No supports required
• Print multiple clips for convenience

_________________________________________________________________________________________________

Thanks for downloading from Chopper Originals.

If this print earned a spot on your printer and you’re out of Boosts, consider buying me a coffee ☕ to help support future designs and releases.

___________________________________________________________________________________

Affiliate Disclosure
Some links in this listing are affiliate links. As an Amazon Associate, I earn from qualifying purchases at no extra cost to you.

____________________________________________________________________________________

Having issues getting that first layer to flow and stick good? Follow these steps, it helps! ***If using an enclosed printer, be sure to remove the lid and leave door open to avoid heat creep***

If using multiple brands/types of filament, you will need to save each as a Custom Filament setting. Otherwise the settings will change when your colors switch.