Nerf/Picatinny Optic OKP-7 red dot sight

I saw this cool-looking optic in several shooter games, so I decided to make it into a NERF blaster attachment! This is the OKP-7. a somewhat uncommon optic used by Russian special forces. This one is specifically based on the version found in Battlefield 6.

This version is compatible with: Most Nerf Elite Series, Elite 2.0, Some Nerf Rival blasters. 
- For some reason doesn’t fit the top rail of the Elite 2.0 Motoblitz, but works on the siderails.

If it is too loose, put some tape on the inside of the attaching mechanism for friction.

Supports are required.
 

Be careful when removing the supports. I recommend using a pair of needle tip plyers. When printing in enclosed printers, keeping the top cover removed or leaving a small gap for airflow could reduce stringing. Lowering printing hotend temps could also help with this, but it shouldn't be a huge issue as long as your filament is dry.

If removing the supports is too hard, you can try tweaking the support settings in Bambu Studio, but it seemed to be fine. (for me)

Better to use petg for better print strength, but unless you drop this a lot pla should be fine.

if you had issues with this print, please explain them in the comments - I will try to improve the design.

Check out my other nerf accessories/attachments: https://makerworld.com/en/collections/19047372-nerf-accessories