Craftsman V-Series/GripEdge 1/2 in Socket Rail Nub

This is for 1/2” drive sockets for the Craftsman V-series Socket Rail Or GripEdge socket rail. Preferably use PTEG with a .4mm nozzle for this print with best results. Might be able to use some PLA but I think it would be to brittle to press in the ball detents.

I have Pictured pressing the spring loaded detention into the nub using a small jewelry sized press but you could probably use a pair of pliers to do it or tap it in with hammer.

You can buy the spring loaded ball cathes on Amazon. Buy the 304 stainless steel 5x6x9mm(15N) ball plunger.

Please check out my other models and give me a like and comment. Please share a picture of your print in the comments. I am open to suggestions and/or requests.