HOLD MY BRUSH! for Samsung Heat Exchanger brush

The Samsung tumbledryers equipped with a heatpump have a heat exchanger component that requires periodic cleaning. Samsung supplies a brush for this with a lovely suctioncup to attach it to things so you can be certain it comes falling down the moment you turn your back on it.

I was very done with the brush laying around in the cupboard next to my tumbledryer and therefore I made this very simple brush holder. There are cutouts in the back to apply double sided tape to attach it where you want it. After my initial testprint I figured the walls were a bit thin, so this file is a bit beefier than the original one I printed this with.

Printed in simple PLA, 2 walls, 10% cubic infil. No support or brim needed whatsoever.