Search models, users, collections, and posts
Lenovo M720Q/M920Q 19-inch rack mount for A1 mini
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
10 h
2 plates
Open in Bambu Studio
Boost
21
86
4
1
65
24
Released
Description
The original model does not fit the 18x18cm print area of the A1 mini. As this is he only printer I own, I adapted the model by cutting each half of the 19" rack unit in half again to fit the build plate and likewise cut off the backside at 150mm, as the original model is 190mm in height. I added a slot and tongue-like construction to assemble the load-bearing parts after printing with enough stability. Parts are glued with CA glue after printing. As I had it lying around I reinforced the lower front connection using a 3d printing pen, as it needs to hold th most weight.
Printed in PLA. Should it deform over time, I'll reprint with PETG.
Same parts needed as the original model:
3x M5 screws
3x M5 hex nuts.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (4)