PiFinder Multi-Position Camera Holder

This is a Multi Position Camera Holder for PiFinder V3 Hardpoints

It allows you to change the direction the camera is facing with by loosening one screw a few turns and has three positive stops.

There are currently 4 versions: LEFT/RIGHT (this is the side it mounts to) and Arducam and PiHQ Camera Versions.

Each plate has a specific orientation configured

Required Hardware:
2x 2.5mm heat set inserts (4-6x for the PiHQ Version)
1 M6x1.0 Socket Head Cap Screw 30-40mm in length (I would not suggest using less than 30mm)
Ideally also a M6 Tap to finish the threads, threads ARE modeled so printing with a fine layer height should work but you will probably want to use some wax to help break in the threads if your printer isn't tuned well.

If you are printing this from the STLs you will need to print vertically and use supports for the camera holder's overhangs I suggest using painted tree supports for the cap-screw recess and for the obvious overhang at the top...

I have included modeled supports to ensure the model doesn't fall over during printing these should just snap off after printing.