Roborock S8 MaxV Ultra Dustbin

DUSTBIN FOR ROBOROCK S8 MAXV ULTRA

This reusable dustbin replaces the original disposable dust bags and allows for comfortable, clean, and quick emptying – completely without consumables.

• The two halves are connected with a 1.75 mm piece of filament that serves as a hinge.
• Two clips securely close the container and allow for easy opening and emptying.
• The gasket is glued into the designated recess.
• The filter used corresponds to that of the robot's original dustbin.
• The container has been optimized and tested for easy use.
• Note: The support on the small part must be removed very carefully to avoid damaging the clip's web.
• The filter fits extremely precisely – when replacing it, it should be removed gently to avoid damage.

Material recommendation:

• Printed from PLA, which in my experience is completely sufficient. (The gasket is made of TPU.)

‼️ Important note: One of the clips can be opened for easier removal. Additionally, a handle has been added to the adapter piece to safely remove the container.

⚠️ Disclaimer: The use of this dustbin is at your own risk. I assume no warranty or liability for any damages that may arise from its use.

👉 See also my dustbin 

❤️ A big thank you to Cyb3r91!
He not only helped me immensely with the development of the bin but also supported me with many valuable feedback and technical ideas. During the exchange, really pleasant and exciting conversations always arose – also about completely different topics concerning 3D printing, technology, and everything around it. Exactly such moments make projects like this special.