Search models, users, collections, and posts
Amane Suzuha Bust Shot Statue
IP Report
This model is created by Image to 3D
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.5 h
1 plate
Open in Bambu Studio
Boost
1
10
0
0
2
1
Released
Description
Amane Suzuha Bust Shot Statue
This model is printable with PLA. The original scale should be 100 mm in height but you can adjust as you may like.
Tree suupport recommend. Careful when take out support from her hair! That may take out her hair too if you pull support out too hard.
(This model is generated using help from AI in MakerLab. The original png was fron the VN sprite of Steins:Gate.)
RECOMMENDED PRINT SETTINGS:
- Layer Height: 0.2mm (I used 0.2 mm and worked just fine. Smaller layer probably work too.)
- Infill: 10–20% (I used 16 %)
- Supports: tree support recommend (30 degrees is okay)
- Material: PLA (PETG Probably can be used. If you try please share if it work or not)
Have fun! El Psy Kongroo!
Boost Me (for free)
If you like the work, Boost me! Thanks!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)