Original Ultimaker2 converted to Sherpa mini extruder
Print Profile(1)
Description
1. Two M3x6x5 heat-set inserts need to be heat-embedded at the connection point;
2. The original thumb screws are replaced with M3x65 + nut fastening. The screws are installed inverted, and the four slots above are used to place the nuts. I used square ones, but others are also acceptable.
3. Can be used with the original cross slide;
4. The Sherpa is relatively wide, so it has been raised a bit to prevent it from hitting the frame;
Hardware list:
M3x6x5 2 pieces
M3x65 4 pieces
M3 nuts 4 pieces
A design ten years overdue, hahaha.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)