Gridfinity 608 Bearing holder (with dust cover)

Holds 16 608 Bearings. Yeah, the same ones you have left over from the fidget-spinner craze 🤪

Because these often have a thin coat of oil, I wanted to add a cover to keep them dust-free,  but the lid is completely optional

The block is 2x2x1/2 units and allows for other gridfinity components to stack on top whether you are using the cover or not.

The pre-sliced files have helper discs in the corners to prevent the corners from lifting due to warping. You can just fold them back and forth a few times and tear them off by hand. Usually, you don't even need to deburr it.

Important Note for Bambu Studio Users:

If using Bambu Studio set your wall generator to Arachne. Otherwise, the “finger holds” on the lid will not print correctly. Thanks, DivineSama for discovering this and sharing the solution!

Hope this is helpful, and please share your makes 😀!