Modular Airbrush Stand Modular Airbrush Stand

The modular airbrush stand can be combined according to the number of airbrushes you use, adaptable and expandable whether you use only one airbrush or need five or more. The angle can be freely rotated, and three sizes of desk clamps are suitable for different desk thicknesses. Assembly requires no glue or screws, and the flexible interlocking structure allows for easy disassembly and expansion with more modules at any time.

Note! Supported airbrush types are shown in the figure below. Airbrushes with front-end air adjustment and siphon-feed cannot be used

————————————————

Assembly instructions:

Assembling the stand requires no glue or screws, just clean off the supports

First, assemble the base. When installing the side structures, please insert from the side with the arrow. If you need a version for multiple airbrushes, you can install the side structures after assembling multiple main bodies
 

Pass the upper part of the stand through the base hole, install the lower part of the stand, then pull the entire assembly into place
 

Insert the fixing clip from the curved side to install the stand onto the edge of the desk

Note: The desktop fixing clip comes in three sizes to accommodate different desk thicknesses. The advantage of the fixing clip is that it has a smaller protrusion under the desk, occupying less under-desk space and providing a cleaner look. In the default print profile, plate 1 includes the S clip, and plate 2 contains the M and L clips. If you need M or L clips, please replace the corresponding parts before printing