Screw lock zip tie wrap
Print Profile(1)
Description
Screw lock reusable zip tie wrap
Insertable from both sides
Dimensions:
Length: 170mm
Tie width: 6mm
Thickness: pt. 6mm or pt. 8mm
Screw container: ~1cm cubed
Thread 1.4mm pitch, 6mm diameter
Print time 10min+ (depending on speed)
Options:
Print at slower speed for increase strength
½ speed for PLA
⅓ speed for PETG
Adjust speeds or flow rate(under project filament edit)
There is a necessary prebridge, slow bridge speed to half if stringing observed in aperture
Green tie wrap shown was printed at 2mm^3/sec
White tie wrap show was printed at 10mm^3/sec (or half default speeds)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)