Low-angle 30-degree camera cowl 3D printed part for FPV racing drones

Recently, some new pilots around me, due to certain circumstances, had to quickly learn to fly 5-inch racing drones in a short time, and then found that no one had ever made a fixed cowl below 40°

So I designed a 30° (ultra-low angle) cowl for all new pilots to use

First, the angle is extremely low - 30°, with the propellers at the bottom ¼ of the screen

The camera mounting screw section of the 3D printed part is 2mm thick, and the maximum screw length used is M2*2 + (the length you want to go into the camera hole)

The spacing between the two sides of the 3D printed part is 14mm, which matches the size of nano cameras commonly used in racing drones

The spacing between the two fixed copper pillars is 24mm (theoretically, any drone with two copper pillars at this spacing can use it)

The height is 26mm, with a semi-circular air intake at the top (might help with cooling a little?)

Finally, drawing is not easy, please boost me! I hope all the pros and new friends never crash and their flying skills get better and better!!!