Fujifilm INSTAX mini Evo lens cap

I love the look but I had a question regarding the fit on the camera. is it supposed to slide right off? if i turn it upside down. the cover will slide right off with very little movement. used print profile, printed with my p2s and a 0.2mm nozzle. used PLA support for the inside so the support wouldn't stick to the cover.

Printed pretty good with a 0.4mm nozzle!

Thanks to your model! I was trying to make it from scratch but its either too loose or too tight. Your size of inner diameter is just right! Tested both PLA and TPU. Kudos for making the "Fujifilm" cover design making it look more authentic but I removed it just for personal preferences. For those who are bothered by having to use support, you may print it upside down (being the front cover in the print bed). I printed the base (gray in photo) with TPU and the star design in PLA (yes, I printed them separately thats why I didnt use support)

I just had to run some abrasive sponge inside because it was too precise and it was difficult to get out, but in 5 minutes with the sponge it was ready

Printed fine and had no issues

If you're using support filament make sure you change both support filaments from default

Add auto support !!! - if you don't use support filament (sup PLA)

turned out great! thank you!

printed single color since I don’t have ams and I came out good, the supports are hard to take off but its good