Moderno Kids Trail Explorer / Jeep Hood Latch

I molded this hood latch as a replacement for my kids Moderno Kids Trail Explorer / Jeep. 
This should fit both the 12volt MKSX2025 and the 24 volt MKSX2585 styles.

You will need x2 M3x12 screws one from each side. 

This part can be printed in PLA, but I recommend using PETG since it holds up better outdoors.
After printing, I used a razor to clean up the edges left by the brim.
For a smoother surface finish on the latch side, try using the opposite filament type (for example, use PLA if your main print is PETG) as an interface layer — it gives a much cleaner result.

If you have any issue or questions please let me know. 



Link to M3 screw kit. I like this one since it was cheep and has more than just the ones I needed for for this project
https://a.co/d/4Ddcsgg  - 2040 Pcs M2 M3 M4 M5 Metric Screw Assortment