X2D, P2S 15mm Spacer, Riser for Glas panel, lid

Here's more for the P2S

✨ A small upgrade with a big impact – Spacers for the Bambu Lab P2S ✨

Yes, I know – there are already quite a few spacers for the Bambu Lab P2S. But they were either too high for me, too plain, or they just didn't quite match the elegant aesthetics of this printer. So I thought to myself: Why not do it myself

🔹 The result: A 15 mm high riser that keeps your P2S glass lid at a distance, not only practically but also stylishly

💡 Special detail: An elegantly integrated cutout for the USB port is located at the front. Not a carelessly cut hole, but a solution that harmoniously blends into the overall design

Since my printer is on my desk and the AMS is on the shelf above it, a clear view from above was important to me – without additional mounts, sliding mechanisms, or other frills

🖤 Filament in the pictures: “Eryone PETG‑CF Dark Grey” – a color-coordinated addition to the P2S, robust, and with a matte finish

!!ATTENTION!!

There are different fits at the joints! Based on my tests, I recommend the following for the riser on the P2S

PLA 0.03mm air gap

PETG 0.03 to 0.05mm air gap

PETG CF or fiber-reinforced 0.07 to 0.11mm air gap, here it is very important that the filament is calibrated

You can also determine this yourself by printing the gap test. For optimal results, I recommend printing at 50% speed for sharp edges