lazzi small gauge matching bracket liner

I liked many knitted little hats and some Nomi hats, and wanted to DIY them onto my car, so I made a liner to make the hats more stable

Tested on Lazzi's dashboard bracket and dashboard bracket with wireless charging, both worked fine

Because each printer has different tolerances, the model itself cannot perfectly snap onto the dashboard bracket, so I used 5 round 8×2mm magnets to secure its position, the bottom has limiters that can be fixed onto the bracket, when installing, it needs to be tilted slightly, first tilt and install one side, then install the other side

I used PETG material, the limiter felt a bit disposable, the rest of the parts had no issues, of course, if possible, I recommend trying materials with higher strength

The default layer height is 0.12mm, if a smoother surface is needed, you can set it to 0.08mm, the printing time will be slightly longer

Regarding supports, I experimented with printing the main body with PETG and used PLA for the support interface, which yielded unexpected good results