Dock for SanDisk Extreme SSD - Free 3D Print Model

Search models, users, collections, and posts

Jonas_H

Household>Office

IP Report

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 3 walls, 15% infill

Designer

1.5 h

1 plate

4.8(9)

A1 Mini - 0.16mm layer, 2 walls, 10% infill

2.6 h

1 plate

Open in Bambu Studio

Boost

127

147

Released

Description

Since I was asked for a variant of my “Dock for the SanDisk Extreme SSD with case”, I have now made this model. This model can now be used without the SanDisk Extreme SSD Enclosure with AirTag compartment.

With this dock, you have a nice setup for your desk where you can easily connect and disconnect your SanDisk Extreme SSD.

I have added some holes for two M4 threaded heat inserts. With these inserts, you can screw the dock onto your desk if you prefer a more secure fit. Alternatively, you can also use double-sided tape. You will be fine as well if you don't use either of these, for a more mobile solution.

For this dock, you will need:

2x M3 thread heat inserts
2x M3x7 screws
1x 90-degree USB-C Adapter, this one to be accurate: https://amzn.to/3HntQcZ (Affiliate Link to support my work)
optional: 2x M4 thread heat inserts

The assembly is pretty straightforward. Install the heat inserts and then the 90-degree USB-C Adapter. Now, simply put on the bottom part, and you are finished.

Happy printing :)

Comment & Rating (16)

@Mjoelnir

Print Profile

0.2mm layer, 3 walls, 15% infill

Simple, elegant, and beautiful! The print went without any issues. I extend my sincerest gratitude for the design

Show original

@RockHound50

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

Love this print.

@RB.Prints

Print Profile

0.2mm layer, 3 walls, 15% infill

The print profile is good most of all. Few blemishes here and there on the extrusion. The size for the Sandisk is also a tad too big. Overall very happy. Thank you!

@aaronolson5

@Jonas_H - I absolutely love this! Would you be open to sharing your design file? Or, if possible, could you create a version that fits the SanDisk Extreme Pro 4TB? I’ve been searching for something like this for ages and would be happy to contribute for your time. Thanks!

@cevetet0

I have both the SanDisk Extreme SSD and the SanDisk Extreme Pro SSD and would like matching docks.

@SnakeP

Unfortunately, the slot for the SSD is too wide and it sits very loosely - a shame... unusable like this.

Show original

@Sounddept

Hey There! First off all let me thank you for sharing this design, in the time I had my Sandisk Extreme it proved very useful keeping the SSD out of the way. How did you manage to work the dimensions of the USB C adapter out? I am wanting to make a dock for the Samsung T7 and I have two of the adapters you used on this print. Any help would be greatly appreciated, thanks!