Search models, users, collections, and posts
Display Case Riser Stand for IKEA KALLAX & DETOLF
Print Profile(1)
0.28mm layer, 3 walls, 10% infill
Designer
9.3 h
1 plate
Open in Bambu Studio
Boost
471
1548
60
41
1.3 k
424
Released
Description
Simple Strong Display Case Riser Stand for IKEA KALLAX & DETOLF Bookshelves and Display Cases
These are simple risers designed to fit Ikea Kallax bookshelf and Detolf display cabinet. Each riser is 6.5" W x 5" D x 4" T. Two of them side by side fit just inside a Kallax shelf width-wise with a bit of wiggle room. The triangular shape on the bottom is to make sure the PLA doesn't cause warping and sagging over time. It still prints without support. I have also cut them in half for a three tiered display.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (60)