RS1 Car Phone Holder

RS1 Phone Holder

Good evening, makers!

I've spent time and energy on this project. I've seen many car phone holders, but they all had flaws, so I took a couple of existing models, disassembled them millimeter by millimeter, analyzed their respective functions, and remodeled them.

I created additional attachments that fit various car vents, long and short, sturdy, and with thin and wide spaces.

The only note is about the back part where the small knob is screwed:  

Remember that you need to assemble everything first, after which unscrew the knob and add a few drops of glue, because if you tighten it too much, you risk stripping the small knob, as it's natural to tighten it all the way to make it more secure, as with everything ^^

I also created a second car phone holder, the GS1. Unlike the RS1, the attachments for car vents are completely different, thus offering more possible solutions. The GS1 file will be included as a print profile.

I remind you to print it in PETG HF from Bambu Lab because PETG is more resistant than PLA on sunny days.

The project is still undergoing continuous updates, and your feedback is also important!

Your support would be appreciated with a boost! Thanks in advance and happy printing everyone!