Search models, users, collections, and posts
Wallmount for 50mm Conduit Pipe
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
14
38
0
0
19
12
Released
Description
This design allows to hold a 50mm conduit pipe and securely mount it on a wall surface with two screws. It's modelled to fit the Kabuflex pipe, but should also work for similar conduits.
Print both halfs and close them around the conduit so they interlock with the grooves. Then bolt them to the wall using two 4mm screws with some fitting wall plugs
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)