3D Printed Darts Target Set

This printable dart target set includes a target board, a simple stand, and lightweight darts.

For best results, print the target with 4 walls, 0 top/bottom layers, and 30–35% Grid infill (31% works perfectly).

To achieve a color change on the outer rings without AMS, set a filament swap at layer 26 (for 0.2 mm layer height).

Print darts with brim and add a modifier on the dart tip to increase wall count to 10 for better weight balance.
 

All these settings are applied in uploaded print profile.

After printing, insert a short piece of filament into the dart’s tip and cut it at an angle to form a point — the tip should be around 20–25 mm long.

For best throwing results, place the target around waist height so that darts fall slightly from above.