Search models, users, collections, and posts
AMS storage - Easy and open
Remixed by
IP Report
Print Profile(3)
AMS2-kit
Designer
4.5 h
1 plate
AMS1-kit
Designer
5.2 h
1 plate
MIX-kit
Designer
4.9 h
1 plate
Open in Bambu Studio
Boost
24
107
6
1
60
14
Released
Bill of Materials
List other parts
- https://www.ikea.com/no/en/p/skadis-pegboard-black-80534372/ x 2: SKÅDIS Pegboard - 805.343.72
Description
The model I took inspiration from (attached as a remix) was supposed to take 16 hours to print — that’s just way too much.
So, I took a different approach to the same problem, which resulted in an 11.5-hour decrease in print time.
NOTE!!!!
There are three different profiles:
-Dobble AMS 2 stack
-Dobble AMS stack
-Mixed stack (One bracket set for each type)
For the material, I strongly suggest using something stronger than PLA. I used PLA for testing, and it broke way too easily under load than ABS.
The AMS 1 brackets can be used for the AMS 2, but not the other way around.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)