Search models, users, collections, and posts
35mm Film Case
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.2 h
1 plate
Open in Bambu Studio
Boost
72
224
20
10
195
86
Released
Description
This is a remix of the original 35mm Film Case with 35mm text engraved into the lid. That way, one can distinguish the boxes, in case one has multiple versions of the rugged box design.
I print my rugged boxes with PLA and the latches with PETG (for a bit more elasticity). Printing the whole box in PETG should be fine as well, though.
6x M4x20mm screws are required for the latches and hinges.
The design includes a seal which needs to be printed with TPU. I haven't used seals with my boxes so far, however.
Thanks to the original creators (Hever Nava & Whity)!
Print settings:
Sparse infill pattern: Gyroid
Bridge direction: 45°. (otherwise the bridge distance will get to long and the engraving will look ugly).
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (20)