Rog Ally Z1 Extreme Ram Cover

I recently purchased the 74WH battery for my Rog Ally and the see through back MODCASE off of amazon. After installing the case i began to run into issues with the Ally, it wouldn't boot first time and was doing all sorts of weird stuff. I thought it was an issue with the 2280 SSD i had installed but after numerous windows installs i narrowed it down to the battery putting too much pressure on the ram chips. I quickly drew this up and chucked it in the Ally and all my troubles have disappeared. This print disperses the pressure off the battery and onto the board rather than onto the ram. Note if you ware also using the MODCASE where the kick stand is located there is a lot of plastic about 2-3mm that also contributes to pushing the battery on the ram so i would also recommend either cutting it out or sanding it flush. Recommend you print in ABS or ASA.