Banani

cover

floral stamps 2.png

floral stamps 3.png

floral stamps 4.png

plate_1.png

2025-10-18_16dfe581bbe508.png

0.16mm layer, 2 walls, 15% infill

PolyReelStudio

IMG_5773.JPG

IMG_5772.JPG

<h2>Print Profile: A1 Mini – Balanced Detail Setup</h2>This profile was set up to run the model on the A1 mini build plate without changing the original geometry in any way.I kept all adjustments strictly within print settings. The initial layer speed is slightly reduced to help with adhesion, and the brim is trimmed down a bit so it’s easier to remove after printing.Layer height is set to 0.18 mm. For this type of stamp, the vertical resolution isn’t as critical, so this helps keep print time reasonable while still capturing the important surface detail. The top surface line width is set to 0.33 mm to get cleaner definition without relying on ironing.I also enabled precise walls and smooth wall speed, and reduced outer wall speed to help with accuracy on finer features. Infill is set to rectilinear with infill combination to keep things efficient while still providing a consistent internal structure.Overall, the goal here was just to make the print more reliable on the A1 mini while respecting the original design.Tested with PLA and PETG.<h3>Notes</h3><ul><li>No changes made to the model itself</li><li>Sized and arranged for A1 mini compatibility</li><li>Adjustments focus on adhesion, accuracy, and surface consistency</li><li>This profile reflects the setup used in the printed photos</li></ul><h3>Credit</h3>All credit to the original designer — this is a really well-made model. This profile is just meant to help it print cleanly and consistently on the A1 mini.

A1 Mini – Balanced Detail 0.18mm layer, 2 walls, 10% infill

Flower and Leaves Stamp Set &nbsp;I did print with a small skirt on these, but if you&#39;re confident in your bed adhesion, it&#39;s probably not necessary.

Flower and Leaves Stamp Set 

ASIA

Print Profile(2)

Description

Comment & Rating (29)

License

Related Models