Steam Deck lightweight front cover - protects joysticks and screen (partial cover version)

I needed a simple and lightweight front cover to protect the joysticks and the screen when traveling light, so I made one.

Two versions: partial front cover (this one), and a full front cover (link).

FULL FRONT COVER COVERING ALSO THE FRONT CORNERS CAN BE DOWNLOADED HERE

• Prints as a single piece in the P1P and X1C (and any larger printer)
• Very light, weights only 50g printed!
• Smooth corners to not snag into other stuff when thrown in a backpack
• Very thin, can flex slightly to fit snugly around the deck

If you prefer a looser fit, increase the width by 1mm. That is, the widest measurement (leave height and length the same). The standard model has a very tight fit and need some flex to install and remove.

I tested in PLA and PETG. PETG fits as well and is more flexible, but the finish is worse due to the supports.

Supports required. I can print with only a few supports depending on angle, but there aren't many choices given the size and complex shape. If you can print without supports on a larger printer, let me know!

Must be positioned diagonally on the bed to fit on the P1P and X1C: