Hat Holder for Wall
Print Profile(1)
Description
Boost Me (for free)
Did you know? MakerWorld gives out free Boost tokens to active users! These tokens can be used to support any model you love -- at no cost to you. You may not even know that you have Boost tokens. But they are a big help to creators. Please show your appreciation by boosting the models that you like.
Tired of hats playing hide-and-seek? Stick this hook to your wall and give your headwear a five-star parking spot—no valet required.
Whether you’re team peel-and-press or squad drill-and-fill, this holder hugs your hats tighter than a toddler clutches candy.
This is a hat holder that can be mounted on the wall without hardware. It is designed to accommodate one large command strip. But you could probably get by with a smaller one. Any double sided sticky tape should work. Command strips are just easier to remove.
One large command strip is rated to support up to about 4 pounds (1.8 kg). This is more than enough to hold up this hook, plus a hat.
Recessed screw holes are included if you prefer to use them.
This model is a modified version of Alesteria's Wall Hat Holder. I fixed overhangs and sharp edges, and replaced the screw holes with recessed versions (so your screw heads don't stick out).
Membership
My models are always available for personal use here, for free. But if you would like to sell physical prints of my models, you can do that if you subscribe to my commercial licensing membership. Thanks for your support!
This remix is based on
License
Comment & Rating (57)