Search models, users, collections, and posts
Ikea Vattenkar Zip Tie Hooks
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Open in Bambu Studio
Boost
1
9
0
0
2
0
Released
Description
These are 2 sizes of zip tie hooks to hang an object under the shelves of an Ikea Vattenkar. You need to print a pair of hooks. You hang them on each opposite sides of a shelf and pass a zip tie in the lower holes.
Support material is not required. An infill of 25% is recommended.
This object's main web page is: https://www.ctheroux.com/ikea-vattenkar-zip-tie-hooks/.
This object was designed using Solid Edge Community Edition.
You can request the source files on the page listed above.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)